On your Raspberry Pi, open the VNC Server dialog. Navigate to Menu Options Troubleshooting and select Enable experimental direct capture mode. On the device you'll use to take control, run VNC Viewer and connect. Note: existing connections must be restarted in order for these changes to take effect.
![]() I'm no expert with Linux, but I managed to get VNCServer running just fine on my RPi 3 B+ so that I could use it in headless mode and, when it was rebooted, VNCServer would start with no problems and I could connect to the Pi's Raspbian desktop from VNC Viewer in Windows 10 with no issues whatsoever. ![]() ![]() I've tried adding 'vncserver' to rc.local, that just locks me out of the usual :1 address and sets up another (:2) which won't display in VNC Viewer. Any one having the same problems? I'm seriously considering going back to the previous version of Raspbian at this rate... ![]() Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |